The use of wheel balancing machine mainly follows the following steps:
First, preparation
1. Tire inflation: The tire is charged to the appropriate air pressure, which is the basis for the balance of the action.
2. Clean the tire: Remove the lead on the tire (if the dynamic balance has been done before), and clean up the stone and other debris in the tire pattern trench, ensure that the tire surface and rim are clean and free of foreign matter.
Second, install the tires
1. Install the balance shaft: Install the balance shaft with the tire mounting surface facing inward, which is to ensure that the tire can rotate stably when measuring.
2. Select the right vertebral body: Select the right vertebral body according to the specifications of the tire, and lock the tire firmly on the balance shaft with the locking device.
Third, measurement and input data
1. Turn on the power: Turn on the power of the balancing machine and prepare to start measuring.
2. Measure distance: Use a ruler to measure the distance between the rim and the balancing machine, and measure the width and diameter of the rim as needed (some balancing machines may require these data).
3. Input data: Input the measured value on the control panel of the balancing machine to ensure the accuracy of the measurement.
Fourth, start measuring
1. Press the Start button: When everything is ready, press the start button on the balancing machine, and the balancing machine will start to drive the tire rotation and start measuring.
2. Wait for the measurement to be completed: The balancing machine automatically measures the unbalance of the tire during the rotation process and automatically stops after the measurement is completed.
Fifth, add a balance block
1. Rotate the tire: Rotate the tire to the position light on the side of the balancing machine, which means that the position needs to add a balance block.
2. Add a balance block: According to the value displayed by the balance machine, add the corresponding grams of balance block in the corresponding position on the inside or outside of the tire. Usually, the balance is tapped into the higher part of the rim.
3. Repeat measurement: After adding the balance block, repeat the above measurement steps until the balance machine is displayed as "00" or close to "00", indicating that the tire has reached a state of dynamic balance.
End your work
1. Take off the tire: After the dynamic balance is completed, turn off the power of the balancing machine and remove the tire that has done the dynamic balance.
Matters needing attention
Make sure the tires and rims are not damaged or deformed before moving into the balance.
Use appropriate tools and equipment to ensure safe operation.
Follow the operation instructions and operating procedures of the balancing machine.
Through the above steps, the wheel balancing machine can be effectively used to balance the action of the tire and improve the stability and safety of the vehicle.
Comentários